Rollover system / Technical overview
YOLO CF370Rollover Car Wash Machine
Five-brush rollover with wheel brushes
A reciprocating system with retractable wheel brushes, four-fan drying and optional unattended controls.
Where it fits
Built around operating requirements.
Use the confirmed model data as a starting point, then validate the complete layout and utility schedule for your site.
Reciprocating in-bay operation
The gantry travels around a stationary vehicle through the selected wash and drying program.
Profile-following brush cleaning
Automatic sensing guides the top and side brushes around the documented vehicle envelope.
Program and site confirmation
Brush layout, wash modes, utilities, rails and service access are checked before site approval.
Model-specific capabilities
What the reviewed product material documents.
These capabilities apply to the referenced model configuration. Final functions and component scope are confirmed in the quotation.
Retractable wheel brushes
Two dedicated wheel brushes extend during the relevant stage to clean wheel surfaces, then retract so the gantry can continue the remaining reciprocating sequence.
Defined seven-stage wash sequence
The documented process moves from pre-rinse and foam through wheel and vertical-brush cleaning, followed by a light rinse, water wax and drying.
Integrated top-and-side airflow
Four fans combine upper and lateral airflow after the brush stages, giving the CF370 a complete wash-and-dry sequence within one reciprocating platform.
Self-service and remote-ready controls
An optional unattended module can connect to compatible operating systems, while the MCU controller provides fault codes and supports documented remote upgrades.
Reference data
Technical specifications.
The values below come from the model-specific material reviewed for this page. They remain subject to the supplied configuration and approved installation drawing.
Self-service integration and remote functions depend on the supplied control package. Confirm interfaces, wash programs and site clearance.
| Machine dimensions (L × W × H) | 2.2 × 3.6 × 3.08 m |
|---|---|
| Installation envelope (L × W × H) | 11 × 4.3 × 3.3 m |
| Maximum vehicle (L × W × H) | 5.4 × 2.1 × 2.1 m |
| Wash cycle | 3 min 55 sec single pass / 4 min 21 sec double pass |
| Water consumption | 85–130 L/car |
| Energy consumption | 0.46–0.65 kWh/car |
| Foam consumption | 10–15 ml/car |
| Wax consumption | 15 ml/car |
| Power supply | AC 380 V / 50 Hz |
| Brush configuration | 5 brushes including 2 retractable wheel brushes |
| Drying configuration | 4 fans |
Before site approval
Bring four inputs
to the project review.
Site drawing
Usable bay dimensions, clear height, entrance, exit, queueing area, drainage and service access.
Local utilities
Voltage, frequency, phase, available power, water supply, compressed air and wastewater arrangement.
Operating target
Expected vehicles per day, peak demand, vehicle mix, wash programs and staffing model.
Project constraints
Climate, local code requirements, construction schedule, shipment route and maintenance access.
View details →
View details →
View details →Buyer resources
Guides for choosing and planning.
Automatic Car Wash Project Planning Toolkit
Plan an automatic car wa…
Read guide →Equipment Insights · 6 min readAutomatic Car Wash Maintenance Checklist: Daily to Annual Tasks
Use a practical automati…
Read guide →Car Wash Guides · 6 min readHow Much Space Does an Automatic Car Wash Need? Site Layout Guide
Plan automatic car wash …
Read guide →Next step
Is YOLO CF370 right for your site?
Send your site dimensions, expected volume and local power supply. We will confirm the suitable configuration and project requirements.